- Fits inside of the Micor mobile
- Has an onboard potentiometer for the Micor squelch
- Has an onboard LM386 audio amplifier for an external 8 ohm
speaker
- Uses a standard speaker jack for the speaker audio
- Has an onboard volume control for the 8 ohm speaker
Programming (Firmware)
- Very easy to set up and operate
- Uses the ICS operating system
- Values entered in seconds, WPM (Even Fractional Decimal Values)
- Uses More, Good, Bad, indications when programming in values and parameters
- All programmable data stored in onboard EEPROM
- Over 50 functions available (and more to come...)
DTMF Control System
- DTMF for programming and control
- 25 DTMF programmable code / function memories
- Each DTMF code can be programmed to be from 1 to 5
digits
- Has DTMF muting (can be disabled)
- <>Setup mode (programming mode) Control op mode and User mode
- In programming mode all functions can be accessed with 2 DTMF digits
Electronic Control System
- High quality JFET opamps - Top audio quality, High output
- High quality JFET transistors used in the audio circuit
- Low rolloff < 50hz CLICK to see the Response Graphs
- Programmable timer for transmitter fan control
- Microprocessor control of encode and decode
- Programmable encode hang time
- Beacon mode
- Programmable Antikerchunker filter
- Discriminator or straight through audio for the receiver
port
- Five high quality pots (Bourns) for level adjustments
- Six LED's for system status indication
- Built in Watchdog timer
- Programmable auxiliary output
CTCSS and COS
- Full control receiver port, COS, audio and it has priority
over repeater receiver
- COS only, CTCSS only, AND, OR functions available on the
repeater port
- Separate Plug for a third party encode / decode module (TS
64)
- Encode is mixed in with the transmitter's audio if enabled
- Voltage and polarity selectable COS input for the control receiver
- Polarity programmable COS and CTCSS inputs for both the receiver port
- Special dedicated 10 pin plug for the repeater port CTCSS
- The repeater port has a programmable encode hang timer and can be enabled / disabled
Other information
- Over 41 Page Manual with Schematic
- New with 1 year warranty
- Large ground plane on board for quiet audio and RFI
protection
- Price $119.95
(click for a bigger image)